Troubleshooting; Faq - Sylvania LC320SLX Owner's Manual

My remote control does not work.
What should I do?
iHow
Comethe Initial SetuP appears every
time Iturn on this unit?
Why I cannot watch some of TV programs?
HoW come there is no imag
connected external devices?
Whenever I entered channel number,
it changes automatically.
Why are captions not displayed entirely ?
Or, captions are delayed behind the
dialogue.
. Check the antenna or cable connection to the main unit.
, Check the batteries of the remote control.
, Check if there is an obstacle between the infrared sensor window and the
remote control.
, Test the signal output. If OK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" on page 36.)
, Aim the remote control directly at the infrared sensor window on the
front of the unit.
, Reduce the distance to the unit.
, Re-insert the batteries with their polarities (+/- signs) as indicated.
, When there is an infrared-equipped device such as PC near this unit, it
may interrupt the remote control signal of this unit.
, Move the infrared-equipped device away from this unit, change the angle
of the infrared sensor or turn off the infrared communication function.
, Connect theRF coaxial cable to the Unit directly and run the initial setup:
Make sure to complete the channel scan before turning offthe unit.
, Make sure autoscan has been completed.
(Refer to"Autoscan" on page 18.)
, Autoscan must be completed when you set up the unit for the first
time or move it to a location where previously unavailable channels are
broadcast.
, The selected channel may not be broadcasting.
, When autoscan is interrupted and not completed,
some channels will not be received. Make sure to complete.
(Refer to "Autoscan" on page 18.)
, The selected channel cannot be viewed by the"Child Lock"setting.
(Refer to "Child Lock" on page 26.)
, The unit requires some kind of antenna input. An indoor antenna (rabbit
ears), an external antenna, or an RF coaxial cable from your wall or cable
receiver / satellite box needs to be plugged into the unit.
.Check if the right input mode is selected by pressing
using [CH A/T1. (Refer to"Switching Each Input Mode"on page1S,)
o Check the antenna or cable connection tothe unit.
. Many digital channels have alternate channel numbers. The unit changes
the numbers automatically to the ones signifying the broadcasting
stations. These are the numbers used for analog broadcasts.
_ Cap!ons that are delayed a few seconds behind the actual dialogue are:
common for live broadcasts, Most captioning p[oduction companies can
display a dialogue to maximum Of 220 Words laer minute. If a dialogue
exceeds that rate, selective editing is used to insure that the Captions
remain up:to date with the current TV screen dialogue.
How can I set the clock? , There is no clock function on this unit.
EN