Weider Pro 6900 User Manual page 16

24. Attach the Low Cable (53) to the U-bracket (45)
with an M8 Washer (59) and an M8 Locknut
(58).
See the inset drawing. Do not overtighten
the M8 Locknut (58); it should be threaded
onto the end of the Low Cable (53} so that
only two threads are showing above the
Locknut.
24
i
58
25. Identify the High Cable (55). Route the High
Cable upward through the Top Frame (4) and
over a Thick Pulley (48).
Attach the Thick Pulley (48) inside the Top
Frame (4) with an M10 x 67mm Bolt (71), two
M10 Washers (57), two 13mm Spacers (52),
and an M10 Locknut (56).
25
48
4
26. Route the High Cable (55) over a Thin Pulley
(47) and downward through the Top Frame (4).
Attach the Thin Pulley (47) inside the Top
Frame (4) with an M10 x 67mm Bolt (71), an
M10 Washer (57), and an 11mm Spacer (86).
Make sure that the Thin Pulley does not fall
out of the Top Frame while you complete
steps 27 and 28.
26
55
47
57
71
16