Lexmark X342N - Multi Function Printer Service Manual page 39

Sub error codes (Continued)
First 6 bytes sub
error code data
Explanation
(xx can be any
value)
The exit sensor at the fuser is activated by a piece of media indicating
89 00 01
there is a piece of media in the machine during POST.
Check for media in the exit of the fuser assembly or redrive assembly.
Feed a sheet of paper, and if the same error occurs after clearing the
fuser or the same error occurs when no media is present, check the exit
sensor assembly.
Paper jam near Tray 1
8E xx 09 x1 The second pick from the MPF or Tray 1 failed when other sheets were
committed to the paper path.
(x1=media source)
Failure to feed from Tray 1. Pages in the paper path have been flushed to
8E xx 08
the output bin.
84 xx 2D Misidentified no gap jam. Engine detected no gap at the at the manual
feed sensor. An attempt was made to open the gap by stopping the feed
rolls. A trailing edge was seen at the input sensor. The manual feeder
sensor is no longer covered.
Go to
Paper jam near Tray 2
8E xx 11 Took too long to ramp up DC feed motor
8E xx 10 Received lots of DC interrupts before losing them
The second pick from the MPF or Tray 1 failed when other sheets were
8E xx 09 x1
committed to the paper path.
(x1=media source)
8E xx 08 Failure to feed from Tray 2. Pages in the paper path have been flushed to
the output bin.
Paper jam near manual feeder.
8E xx 09 x1 The second pick from the MPF or Tray 1 failed when other sheets were
committed to the paper path.
(x1=media source)
Failure to feed from Tray 1. Pages in the paper path have been flushed to
8E xx 08
the output bin.
84 xx 3B Paper never reached the input sensor from the manual feeder.
Possible cause: Defective input sensor
"A4, oversized paperfeed service check" on page
7003-XXX
Possible
error
message
202.13
241.00
241.12
241.16
241.18
2-30.
242.00
242.01
242.08
242.12
242.16
251.00
251.12
251.11
251.19
2-17
Diagnostic information