Lexmark X342N - Multi Function Printer Service Manual page 33

Printer specific user attendance messages (Continued)
Message
34 Short Paper
37 Insufficient
Collation Area
38 Memory Full
54 Std Network
Software Error
56 Standard USB
Port Disabled
84 Photoconductor Life
Warning
84 Replace Photoconductor
88 Toner Low
Explanation
The MFP determines the paper length is too short to print the formatted data.
This occurs when the MFP does not know the actual paper size loaded in the
tray. Make sure the Paper Size setting is correct for the size paper that is being
used.
The following actions may be taken:
Press or Start to clear the message and continue printing.
Press Stop to cancel the job.
This message displays when the MFP memory is insufficient to collate the
pages of the print job.
Press or Start to clear the message.
Press Stop to cancel the job.
This message displays when the MFP is processing an incoming job and there
is insufficient memory available to continue processing the job. The following
actions may be taken:
• Press or Start to clear the message and continue printing.
• Press Stop to cancel the print job.
Clearing the error this way may cause data loss.
This error displays when a network port is detected, but the MFP cannot
establish communications with it.
Press Go to clear the message. The MFP disables all communications to the
network interface.
Displayed when status is requested over the USB port, but the port has been
disabled. Once the error has been displayed for the first time, reporting of further
errors is suppressed until the menus are entered or the MFP is reset.
The following actions may be taken:
• Press Go to clear the message. The MFP discards any data received on the
USB port.
• Press Menu until Busy/Waiting appears, and select Reset Printer.
This message displays when the photoconductor unit is near end of life.
Press or Start to clear the message and continue printing.
Press Stop to cancel the job being processed.
This message displays when the photoconductor is at the end of life. The
photoconductor must be replaced.
This message displays when toner low occurs and the toner low alarm is
activated.
Press or Start to clear the message and continue printing.
Press Stop to cancel the job being processed.
7003-XXX
2-11
Diagnostic information