Brother HE-800B Instruction Manual page 27

Operator
Green and yellow wire
(ground wire)
HE-800B
<100 V / 400 V system>
(1) Power switch
(2) Screws [2 pcs]
4145M
(3) Transformer box
4758M
(4) Transformer box plates [2 pcs]
(5) Screw [with washer]
(6) 3-pin power supply connector
(7) Staples [6 pcs]
(8) Cord clamps [2 pcs]
(9) Power cord
1. Attach an appropriate plug to the
power cord (9). (The green and
yellow wire is the ground wire.)
2. Insert the
properly-grounded AC power supply.
* The inside of the control box uses
single-phase power.
NOTE:
• If the ground connection is not
secure, electric shocks, operating
errors or damage
components such as P.C. boards
may occur.
• Take care when tapping in the
staples (7) to make sure that they do
not pierce the cords.
• Do not use
otherwise
problems may result.
3. Use the six screws to tighten the
cover of the control box. Check that
none of the cords are being clamped
by the cover at this time.
4936M
3. INSTALLATION
power plug into a
to electronic
extension cords,
machine operation
18