Earth Leakage Circuit Protector - Epson AcuLaser M8000 Series User Manual

❏ Connect your printer to an electrical outlet that meets the power requirements of this printer.
Your printer's power requirements are indicated on a label attached to the printer. If you are not
sure of the power supply specifications in your area, contact your local power company or consult
your dealer.
❏ If you use an extension cord, make sure that the total of the ampere ratings on the products
plugged into the extension cord does not exceed the extension cord ampere rating.
❏ When connecting this product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
❏ When you use optional paper cassette units, be sure to install the stabilizers, which come with
the optional paper cassette unit, to the bottom. See "Installing the optional paper cassette unit"
on page 108 for instructions on how to install the stabilizers.

Earth leakage circuit protector

The printer has an earth leakage circuit protector on its back. If any earth leakage occurs on the
printer, the protector breaks the electric circuit automatically to avoid fire or any other accidents.
Be sure to ground the printer so that the protector can operate properly.
Periodically (once a month) check if the protector operates properly by following the instructions
below.
1. Turn off the printer.
Note:
Leave the power cord connected to the electrical outlet.
2. Press the test button. If the circuit breaker switch turns to OFF, the protector operates correctly.
EPSON AcuLaser M8000 Series
Safety Instructions
User's Guide
15