Brother Entrepreneur Pro PR-1000 Operation Manual page 15

d
Select the reference edge and reference point
of the selected pattern for connecting the
next pattern. Since, in this example, we will
connect the center point of the right edge for
the first pattern with the center point of the
left edge for the next pattern, select the
center point of the right edge, and then press
.
• To cancel the selection, press
a Reference edge and reference point of first pattern
→
appears in the screen, and then
changes to
14
.
a
.
e
Press , then press
press the start/stop button to embroider the
first pattern.
f
When the following message appears, press
.
→ The carriage will move.
g
Prepare two embroidery positioning stickers.
We will follow the on-screen instructions to
affix these two stickers to the fabric so that
the positioning marks can be detected by the
camera.
Note
• Use the positioning stickers included with this
product or purchase replacement stickers (SAEPS2,
EPS2: XF0763-001) from your Brother dealer. If any
other sticker is used, the camera may not recognize
it.
• The 182 mm × 257 mm (7 inches × 10 inches)
embroidery positioning sticker sheet with strong
adhesion is most appropriate for connecting
patterns (SAEPS2, EPS2: XF0763-001). If any other
positioning sticker is used, it may peel off. If the
sticker peels off, the patterns cannot be connected.
and then