Factory Reset; Version - Epson 60 Operator's Manual

ADJUSTING THE PRINTER SETTINGS

FACTORY RESET

Use this feature to reset all Level 1 and Level 2 settings to their factory settings.
Note: If you wish to reset the Level 1 settings, but not the Level 2 settings:
Use the LOAD MACRO routine to load macro 0 (see page 32).
If you wish to reset the Level 2 settings, but not the Level 1 settings:
Store the current Level 1 settings as a macro (see SAVE MACRO, page 31).
Then do the FACTORY RESET procedure as stated below. Then reload the
macro that you just stored containing your Level 1 settings (see LOAD
MACRO, page 32).
1. Enter Level 2 mode (see page 34).
2. Press or
played.
3.
4. Reset the machine:
Caution: Do not turn off the printer until the READY message appears on the
display. If you turn the printer off too soon, you may see "START UP ERROR" the
next time you turn on the printer. See page 47 for how to clear the error.

VERSION

Use this feature if you wish to display the version number of the printer's control soft -
ware and fonts.
1. Enter Level 2 mode (see page 34).
2. Press or
3. . The printer control software (C-ROM) ver -
sion number is displayed.
4. Press or
displayed.
5.
6. twice to return to printer "Ready" mode.
42
until FACTORY RESET is dis -
until VERSION is displayed.
. The font version number is