HP 9000 Integrity rp8440 Installation Manual page 84

Table 2-6 Factory-Integrated Installation Checklist (continued)
Procedure
Move cabinet and equipment to
computer room
Move cabinet into final position
Position cabinet next to each
other (approx. 1/2 inch)
Adjust leveling feet
Install anti tip plates
Inspect cables for proper
installation
Set up CE tool and connect to
Remote RS-232 port on MP
Apply power to cabinet
(Housekeeping)
Check power to BPSs
Log in to MP
Set LAN IP address on MP
Connect customer console
Set up network on customer
console
Verify LAN connection
Verify presence of cells
Power on cabinet (48 V)
Verify system configuration and
set boot parameters
Set automatic system restart
Boot partitions
Configure remote login (if
required).
Verify remote link (if required).
Install non-factory, integrated
I/O cards (if required)
Select PCI card slot
Install PCI card
Verify installation
Route cables using the cable
management arm
Install other peripherals (if
required)
Perform visual inspection and
complete installation
84 Installing the System
In-process Completed