HP ProLiant SL165z - G6 Server Configuration Manual page 37

Reboot the system to check the system can boot normally or not.
5.
If the system can't boot, please rebuild the HP crisis recovery USB key or floppy disk, then redo
6.
step2 to step5.
Following is the solution to create a HP crisis recovery USB key or floppy disk, firstly, please get the
ROMPAQ package
To create a Crisis Recovery floppy:
Close all other applications before launching HP Crisis Recovery floppy ROMPAQ Setup Utility.
1.
On the Windows Task Bar select Start, then Run, and enter the following on the command line:
2.
cmd
In the command prompt window enter the following command line:
3.
[Path]\floppy[Enter]
X
Y
(Path is where the ROMPAQ package is loaded; Where x is the drive letter of the floppy)
Follow the instructions to complete the preparation of the floppy.
4.
Upon completion, the user is notified that the file copy is complete.
5.
To create a disaster recovery USB key:
Close all other applications before launching HP USB Key ROMPAQ Setup Utility.
1.
On the Windows Task Bar select Start, then Run, and enter the following on the command line:
2.
cmd
In the command prompt window enter the following command line:
3.
[Path]\install x:
(Path is where the ROMPAQ package is loaded; Where x is the drive letter of the USB flash
media device)
Follow the instructions to complete the preparation of the USB flash media device.
4.
Upon completion, the user is notified that the file copy is complete.
5.
Contents 37