Scalable Fonts
The size of the Roman, Sans Serif, Roman T, and Sans Serif H fonts can be selected
from 8 to 32 points in 2-point increments through your software or by sending an
ESC/P 2 command. See the documentation that came with your application for
information on selecting the size of scalable fonts.
Maintaining the Printer
If you're printing from DOS applications, you can perform most printer maintenance
operations—such as replacing the ink cartridges and cleaning the print heads—as
described in "Maintaining Your Printer" on page 48. However, you'll need to follow
the steps in this section if you need to align the print head to correct misaligned
vertical lines.
Aligning the Print Head with the DOS Utility
To use this utility, follow these steps:
1. Insert the printer software into your CD-ROM drive.
2. Type
D:\SETUP
drive letter, or if you are using the floppy disk version, substitute the appropriate
letter for
the print head alignment utility.
36
at the DOS prompt. (If your CD-ROM driver has a different
.) Then press
D
Enter
, and follow the directions on the screen to install