HP ProLiant DL388 Troubleshooting Manual page 143

Audible Beeps: None
Possible Cause: The firmware does not support the number of devices currently attached to the controller.
Action:
•
If release notes indicate that support for additional devices has been added, upgrade to the latest
version of controller firmware.
•
Remove some of the devices attached to the controller.
1719-Slot X Drive Array - A controller failure event occurred prior to this power-up
(previous lock-up code = 0x####)
Audible Beeps: None
Possible Cause: A controller failure event occurred before the server powered up.
Action: Install the latest version of controller firmware. If the condition persists, then replace the controller.
1720-Slot X Drive Array - S.M.A.R.T. Hard Drive(s) Detect Imminent Failure SCSI: Port
Y: SCSI ID Z.
Audible Beeps: None
Possible Cause: A hard drive SMART predictive failure condition is detected. It may fail at some time in the
future.
Action:
•
If this drive is part of a non-fault-tolerant configuration, back up all data before replacing the drive and
restore all data afterward.
•
If this drive is part of a fault-tolerant configuration, do not replace this drive unless all other drives in the
array are online.
1720-S.M.A.R.T. Hard Drive Detects Imminent Failure
Audible Beeps: None
Possible Cause: A hard drive SMART predictive failure condition is detected. It may fail at some time in the
future.
Action:
•
If configured as a non-RAID 0 array, replace the failing or failed drive. Refer to the server
documentation.
•
If configured as a RAID 0 array or non-RAID setup, back up the drive or drives, replace the drive, and
restore the system.
1721-Slot X Drive Array - Drive Parameter Tracking Predicts Imminent Failure...
...The following devices should be replaced when conditions permit. Do not replace drive unless all other drives in the
array are on-line! Back up data before replacing drive(s) if using RAID 0.
Error messages 143