Cf_Terminal Command; Cf_Autosetuppcadj Command; Cf_Autosetup; Cf_Inputsearch Command - Sanyo PLC-XL51 - 2700 Lumens Manual

PLC-XL51 Expand Serial Command Functional Specifications

8.10.9 CF_TERMINAL Command

Command "CF_TERMINAL_%1"[CR]
"COMPUTER" --------------------- Select "Computer " for Terminal setting
%1
"MONITOR" ------------------------ Select "Monitor Out" for Terminal setting
Set Terminal (Available only in the normal Power ON status)
Details
Terminal for Computer input is Computer 2 in this model.
Acceptable
Response
Unacceptable

8.10.10 CF_AUTOSETUPPCADJ Command

Command "CF_AUTOSETUPPCADJ_%1"[CR]
"ON" ------------------- Set Auto PC ADJ. function to ON
%1
"OFF" ------------------ Set Auto PC ADJ. function to OFF
Set/Cancel Auto PC adj. function
This command is available in normal Power ON status.
Details Note) It is unable to set both Input search and PC ADJ. OFF. If projector receives
Auto PC ADJ. OFF command while Input search is OFF, it returns error code
"101".
Acceptable
Response
Unacceptable

8.10.11 CF_AUTOSETUP

Command "CF_AUTOSETUP_%1"[CR]
%1 "START" ------------------- Execute Auto Setup
Execute Auto Setup
Details Note) CF commands cannot be executed when Auto setup is in process. If the
command is sent during the process, projector returns error code "302"
Acceptable
Response
Unacceptable

8.10.12 CF_INPUTSEARCH Command

Command "CF_INPUTSEARCH_%1"[CR]
"OFF" ------------------------- Set Input search operation to OFF
%1 "ON1" ------------------------- Set Input search operation to On1
"ON2" ------------------------- Set Input search operation to On2
Set Input search operation mode.
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
Details This command is available in normal Power ON status.
Note) It is unable to set both Input search and PC ADJ. OFF. If projector receives
Input search OFF command when Auto PC ADJ. is OFF, it returns error code
"101".
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
When Input is Computer 2, the projector returns "101" and the
command is not executed
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
32/63