Fan; Fan Control; Video Delay Control; English - Panasonic PT-VW430U Operating Instructions Manual

PIN code lock
J
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
1 ) Press ▲▼ to select the desired items
as below.

Off

Unlocked.
Enter the PIN code every time
On 1
turning on the projector.
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
On 2
AC power cord is connected, the
projector can be operated without
a PIN code.
Attention
Whenever you change the PIN code lock setting or the
z
PIN code (the four-digit number), you are required to
enter the PIN code. The "1234" is set as the initial PIN
code at the factory.
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
1 ) Press ▲▼ to select [PIN code change]
and then Press <ENTER> button.
Current Pin code dialog box appears.
z
2 ) Press ▲▼ to enter the current code.
Press ► button to fix the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears.
z
3 ) Repeat these steps to set a new PIN
code.
Attention
Be sure to note the new PIN code and keep it on hand. If
z
you lost the number, you could no longer change the PIN
code setting.

Fan

1 ) Press ▲▼ to select [Fan] and then
Press <ENTER> button.
2 ) Press ▲▼ to select one option .
This function provides the following options in
z
the cooling fans' operation when the projector is
turned off.
L 1 Normal operation.
Slower and lower-sound than
the normal operation (L 1), but
L 2
it takes more time to cool the
projector down.

Fan control

1 ) Press ▲▼ to select [Fan control] and
then Press <ENTER> button.
2 ) Press ▲▼ to select one among
options as below.
Choose the running speed of cooling fans from
z
the following options according to the ground
elevation under which you use the projector.
Off Normal speed.*
On 1 Faster than [Off] mode.*
On 2 Faster than [On 1] mode.*
*1 : Set this function to [Off] when using the projector
in non-high altitude environment.
*2 : When using the projector in the elevation of
above 1 200 m and below 2 000 m, make sure
[Fan control] is set to [On 1].
*3 : When using the projector in the elevation of
above 2 000 m and below 2 700 m, make sure
[Fan control] is set to [On 2].
Note
Failure to set the running speed of cooling fans
z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].
z

Video delay control

This function allows you to make a digital processing
of a projected image faster.
1 ) Press ▲▼ to select [Video delay
control] and then Press the <ENTER>
button.
2 ) Press ▲▼ to select one item between
[On] and [Off].
Note
[Noise reduction] and [Progressive] can not be
z
selected when [Video delay control] function is set
to [On].
Setting
1
2
3
57

ENGLISH -