Kyocera FS-1350DN Operation Manual page 75

Message
Paper path error
Print overrun
Press GO
RAM disk error##
Press GO
Replace toner
Clean printer
Toner low
Unknown toner
installed
USB memory err##
Press GO
Use alternative?
Cassette 1
Wrong ID
Wrong Password
Troubleshooting
Corrective Action
When one or more optional feeders are installed, this message will appear if any of the paper
feeders or the printer cassette upper than the selected one is not properly closed.
The print job transferred to the printer was too complex to print on a page. Press [GO] to
resume printing. (A page break may be automatically inserted in some places.)
You can abandon printing by pressing [Cancel].
If Auto Error Clear is set to On, printing will be automatically resumed after a preset
period of time.
A RAM disk error has occurred. Look at the error code given in place of ## and refer to
Storage Error Codes on page 5-8. To ignore the RAM disk error, press [GO].
Toner has run out in the toner container. Replace the toner container using a new toner kit.
The printer does not operate when this message is displayed.
Replace the toner container using a new toner kit.
Displayed when the installed toner is not the original Kyocera product. Install original Kyocera
toner.
An error has occurred in the USB flash memory. Look at the error code given in place of ##
and refer to CompactFlash (CF) Card and USB Flash Memory Errors on page 5-8. To return
the printer to the print-ready status, press [GO].
When the cassette does not contain any paper that matches the print data (paper size and
type), this message allows you to specify an alternative cassette to use instead. A paper
source number is only displayed when an optional paper feeder is installed. To print from a
different paper source, refer to Paper Feed Mode (Setting the paper feed source) section in
the Advanced Operation Guide.
The ID or Password entered for the Security or Administrator function is not correct. Check
the ID or Password.
For more information, refer to Security section and Admin (Administrator settings) section in
the Advanced Operation Guide.
The password does not match the password set. Enter the correct password. For more
information, refer to Security section and Admin (Administrator settings) section in the
Advanced Operation Guide.
5-7