Error Messages - Kyocera FS-1350DN Operation Manual

Message
Add paper MPTray
Call service
F###:
Call service
### # :0123456
Canceling data
Cassette #
not loaded
Clean printer
Press GO
Close
top cover
Device busy
Duplex disabled
Press GO
Error.Power off.
F###
Error.Power off.
F000
Troubleshooting

Error Messages

The following table lists errors and maintenance messages that you can
be dealt with by yourself.
If Call service or Error.Power off. is displayed, turn off the
printer then turn it back on to see if the printer has recovered. If the
printer has not recovered, turn off the printer, disconnect the power cord,
and contact your service representative or authorized service center.
Some errors cause the alarm to sound. To stop the alarm, press
[Cancel].
Corrective Action
The paper has run out in the paper source displayed. Supply paper according to the paper
source displayed (paper cassettes, MP tray, or optional paper feeders).This message is
displayed alternately with messages indicating the printer status, such as, Ready, Please
wait, and Processing.
F### represents a controller error (#=0, 1, 2, ...). Call for service representative. The printer
does not operate when this message is displayed.
#### represents a mechanical error (#=0, 1, 2, ...). Call for service representative. The
printer does not operate when this message is displayed. The total number of pages printed
is also indicated, e.g. 0123456.
Displayed when data is being canceled.
The corresponding paper cassette is not installed. Install the cassette. The cassette number
can be 1 (topmost) to 4 (bottom).
Please clean the inside of the printer. Refer to Cleaning the Printer on page 4-6.
This message will be displayed when replacing the toner container after the message
Replace toner Clean printer is displayed. After cleaning the inside of the printer,
press [GO] and the printer will be ready for printing.
The top cover of the printer is open. Close the printer top cover.
This message is displayed when Remove Device was selected while a USB flash memory
was being used.
The previous screen is displayed again 1 or 2 seconds.
You attempted to print with a paper size and paper type that cannot be used for duplex
printing. Press [GO] to print onto one-side of the paper only.
You can select an alternative paper size and type by pressing the
press [MENU] and change the tray setting inside the menu, which will automatically cancel
the error and output resumes. At the same time [ATTENTION] indicator will light up and
[READY] indicator will start flashing.
Turn the power switch off and then back on again. If this message still remains, turn the
power switch off, and contact your service representative or authorized service center.
The printer controller and operation panel cannot exchange data. Turn the printer off and
unplug it from the mains power supply. Then contact your service representative or
authorized service center. See the back page of this manual for the relevant phone numbers.
or . You can also
5-5