Table of Contents
Advertisement
Available languages
Available languages
ENGBNE
Maintenance,
repair, or replacement
of
the emission
control devices and sys-
tems, which are being done at the
customers
expense, may be per-
formed by any non-road
engine repair
establishment
or individual.
Warranty
repairs must be performed
by an au-
thorized engine manufacturer's
service
outlet.
TO ADJUST THROTTLE
CONTROL
CABLE
• Loosen cable clamp screw to allow
cable to move.
= Move throttle control lever on upper han-
dle to "FAST" position.
° Pull throttle cable out to end of travel
° Hold cable in this position and tighten
clamp screw securely.
FINAL SETTING
° Start engine and allow to warm for five
minutes.
o With throttle control lever in "SLOW"
position°
IDLE RPM ADJUSTMENT
= To adjust idle RPM, rotate throttle link-
age counterclockwise
and hold against
stop while adjusting idle speed adjusting
screw to obtain t750 RPM.
Release
throttle linkage.
High speed stop is factory adjusted.
Do
not adjust or damage may result.
IMPORTANT:
Never tamper with the en-
gine governor, which is factory set for
proper engine speed,
overspeeding
the
engine above the factory high speed set-
ting can be dangerous.
If you think the
engine-governed
high speed needs adjust-
ing, contact your nearest authorized
ser-
vice center/department,
which has the
proper equipment and experience
to make
any necessary
adjustments.
Cable
Clamp Screw
TO ADJUST CARBURETOR
The carburetor has a high speed jet and
has been preset at the factory and adjust-
ment should not be necessary. However,
minor adjustments may be required to
compensate
for differences
in fuel, temper_
ature, altitude or load. tf the carburetor
does need adjustment,
proceed as follows.
Idle Speed
Adjustin!
Screw
Valve
Linkage
18
Advertisement
Table of Contents
