Advertisement
KEYLESS
CHUCK
See Figure 11.
A keyless chuck has been provided with your drill to allow
for easy installation and removat of bits. As the name
implies, you can hand tighten or release drill bits in the
chuck jaws. Arrows on the chuck indicate which direction
to rotate the chuck sleeve in order to LOCK (tighten) or
UNLOCK (release) the chuck jaws. Loosen the chuck
sleeve by rotating it counterclockwise with one hand.
Insert drill bit straight into the chuck the full length of the
jaws, and tighten securely by rotating the chuck sleeve in
clockwise direction.
UNLOCK
(Release)
DRILLBIT
CHUCKJAWS
LOCK
(Tighten)
CHUCKSLEEVE
/
Fig. 11
,_
WARNING:
Do not hold chuck sleeve with one hand
and use power of the drill to tighten chuck jaws on
drill bit. Chuck sleeve could slip in your hand or your
hand could slip and come in contact with rotating drill
bit. This could cause an accident resulting in serious
personal injury.
ADJUSTABLE
TORQUE
CLUTCH
Your drill is equipped with an adjustable torque clutch for
driving different types of screws into different materials.
The proper setting depends on the type of material and
the size of screw you are using.
TO ADJUST
TORQUE
•
Identify the twenty four torque indicator settings
located on the front of your drill. See Figure 12.
•
Rotate adjusting ring to the desired setting.
1 - 4
For driving small screws.
5 - 8
For driving screws into soft
material.
9 - 12
For driving screws into soft and
hard materials.
• 13 - 16
For driving screws in hard wood.
• 17 - 20
For driving large screws.
• 21 --_11
For heavy drilling.
Note: Remember the two-speed feature (HI-LO) when
setting torque. The amount of torque will vary depending
on which speed setting you have your drill-driver. Switch-
ing to LO speed will increase torque. Switching to HI
speed will decrease torque,
ADJUSTING RING
TO DECREASE
TORQUE
TOINCREASE
TORQUE
Fig. 12
13
Advertisement
