Mounting The Motor; Wing Nut; Item Description Qty; Belt Tension Stud - Sears Craftsman 113.248211 Owner's Manual

BOTH MODELS
MOUNTING THE MOTOR
1. Find the following parts:
ITEM DESCRIPTION QTY.
A Motor .............................................................. 1
B Spacer (#10 x 1/4) .......................................... 3
C Flanged Locknut #10-32 ................................ 4
D Wing Nut 5/16-18 ........................................... 1
E Motor Pulleyw/Set Screw
(Model 113.248321) ................................... 1
F Belt Tension Stud ........................................... 1
G Motor Pulleyw/Set Screw
(Model 113. 248211) .................................. 1
H Poly "V" Belt ................................................... 1
I Key 3/16 Sq x 15/16 ...................................... 1
*NOT SHOWN TO SCALE
2. Place the three (3) spacers onto the three motor
studs as shown. Pay attention to where the oil plug is
located, No spacer goes on the fourth motor stud.
MODEL 113.248211 ONLY
3. Locate the correct motor pulley (has no step). Place
the shaft key intothe groove on the motorshaft. Align
the groove in the pulley with the shaft key and install
the motor pulley onto the motor shaft with the set
screw boss toward the motor. Positionthe outerlace
of the pulley 2 inches from the end shield of the motor
and tighten the set screw using a 1/8-inch hex "L"
wrench.
PULLEY
OIL PLUG
MODEL 113.248321 ONLY
4. Locate the correct motor pulley (Model 113.248211
has "one-step" pulley). Place the shaft key into the
groove on the motor shaft. Align the groove in the
pulley wit h the shaft key and install the motor pulley on
the motor shaft with the setscrew boss toward the
motor,
e
14