Positioning Motor On Motor Mounting Base - Sears Craftsman 113.274600C Owner's Manual

17. Place RIP FENCE on table ...
CAREFULLY move it against blade so that it is
parallel to the blade, and just TOUCHES tips of saw
teeth ... tighten RIP FENCE LOCK LEVER.
18. Insert folded paper between SPREADER AND
FENCE .
19. Using a 7/16 in. wrench, loosen the 1/4-20 hex head
screws so the spreader can slide sideways.
20. Hold spreader flat against folded paper and
fence ... tighten screws using 7/16 in. wrench. Move
fence away from blade. Remove folded paper and
Hex "L" wrench . Lower antikickback pawls and
guard.
21. To remove BLADE GUARD AND SPREADER,
loosen THUMBSCREW ... DO NOT LOOSEN
OTHER SCREWS. This lets you remove and re-
place the guard without disturbing the spreader
alignment.
POSITIONING MOTOR ON MOTOR
MOUNTING BASE
1. Put the motor mounting base against the flat surface
of a workbench.
2. Position the motor so the end with terminal cover is
facing you.
3. Loosen both cradle clamp screws.
4. Put a square against the LEFT side of the motor and
against the top of the workbench.
5. Turn the motor inside the cradle clamps until the top
of both capacitors touch the square.
6. Tighten both cradle clamp screws to hold the motor
in this position.
WARNING: Failure to properly install motor may
let wor!<piece strike capacitor cover during bevel
or compound mitre cuts. Workpiece could bind
and kickback. You could be cut or hit.
CAPACITORS
SQUARE
35