Sears Craftsman 113.248211 Owner's Manual page 34

BOTH MODELS
6.Install the special non-metallic blade guides supplied
with the 1/16-inch blade as sho_n. Separate these
guides as far as they will go.
BACKUP BEARING
SEPERATE GUIDES
AS FAR AS POSSIBLE
7. Uncoilthe 1/16-inch blade and place over the wheels
with lhe teeth facing front of saw and pointing down
towards the lable.
WARNING: TO avoid serious eye Injury or
scrapes, the blade should suddenly uncoil,
wear safety goggles. Carefully uncoil the blade
homing It at arms length.
NOTE: It thebladewill not reachamur,d bethwheets,
lower the upper wheel by turning the blade tension
knob counterclockwise to the "0" position.
8. Turn the tension knob clockwise to adjust tension to
the sanding position (the letter"S"). This isthe correct
tension for the 1/16-inoh blade.
TURN TO
"0" POSITION
+ i
9. Turn 1he upperwheel by hand a fewlirnes and turnthe
tracking adjustment screw to keep the 1/16-inch
blade running in lhe center of the upper wheel.
TRACKING ADJUSTMENT SCREW
r
34