Table of Contents
Advertisement
(2)
SCSI connector and power supply connector
The connector for the SCSI bus is an unshielded SCA-2 connector conforming to SCSI-3 type
which has two 40-pin rows spaced 1.27 mm (0.05 inch) apart. The power connector is included in
the SCSI connector.
Figure 4.14 shows the SCSI connector. See Section B.1 in Appendix B for signal assignments on
the connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections 1.3
"Physical Requirements" and Section 1.4 "Electrical Requirements" of the SCSI Physical Interface
Specifications.
(3)
Connector for external operator panel
This connector is not available for NC model drives.
4-12
Figure 4.14 SCA2 type 16-bit SCSI connector
C141-E226
Advertisement
Table of Contents
Troubleshooting
