Removing And Replacing The Camera Module - Dell Vostro 1400 Service Manual

Back to Contents Page
Camera Module
Dell™ Inspiron™ 1420/Dell Vostro™ 1400
Service Manual
Removing and Replacing the Camera Module
Removing and Replacing the Camera Module
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as the back panel on the computer.
1. Follow the instructions in Before You
2. Remove the display bezel (see
3. Lift the cable securing tab, and then gently pull the camera module cable from the connector.
4. Remove the two M2 x 3-mm screws securing camera module to the display assembly.
5. Gently lift the camera module.
6. Install the replacement camera and tighten the two M2 x 3-mm screws.
7. Insert the camera module cable in the connector and press down the securing tab.
8. Replace the display bezel (see
1 display
3 camera
Back to Contents Page
Begin.
Removing the Display Bezel).
Replacing the Display Bezel).
2 screws (2)
4 camera module