Removing The Microprocessor Thermal-Cooling Assembly; Replacing The Microprocessor Thermal-Cooling Assembly - Dell Vostro 1400 Service Manual
Service manual
Hide thumbs
Also See for Vostro 1400:
- Owner's manual (248 pages) ,
- Driver installation manual (2 pages) ,
- Quick setup (2 pages)
Table of Contents
Advertisement
Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Inspiron™ 1420/Dell Vostro™ 1400
Service Manual
Removing the Microprocessor Thermal-Cooling Assembly
Replacing the Microprocessor Thermal-Cooling Assembly
Removing the Microprocessor Thermal-Cooling Assembly
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as the back panel on the computer.
1. Follow the instructions in
Before You
2. Loosen the three captive screws securing the microprocessor module cover, then remove the cover and set it aside.
1
microprocessor module cover
3. Loosen the four captive screws securing the microprocessor thermal- cooling assembly to the system board, then carefully lift the assembly straight out
of the computer.
1
microprocessor thermal-cooling assembly
Replacing the Microprocessor Thermal-Cooling Assembly
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
Begin.
2
captive screws (3)
2
screws (4)
Hide quick links:
Advertisement
Table of Contents
