Advertisement
7. Place assembled gun and wand on pressure
washer holder.
Pull the cord under the wire bracket to the
right of the wire loop.
Lift the pull cord handle up and slide the cord
to the left sliding the cord into the wire loop.
Next slide handle behind the wire bracket to
the left of the wire loop.
Engine recoil will pull the cord into its final
position.
8, Place pull cord intothewire
bracket holder.
Pull the cord under the wire bracket to the right
of the wire loop.
Checklist
Before going any further please review the following:
• Be sure you have completed assembly instructions.
• Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres-
sure washer be sure to check engine oil (See Opera-
tion under Adding EngineOil.)
Know Your High Pressure
Washer
Read this Owner's Manual and Safety Rules before
operation of your High Pressure Washer Compare
this illustrationwith our pressure washer to familiarize
yourself with the location of various controlsand
adjustments. Save this manual for future reference.
PUMP-
Develops high pressure.
PRESSURE
REGULATOR-
Allows you to adjust the
pressure of the outlet stream.
ENGINE RUN/STOP
SWITCH-
Sets engine in starting
mode for recoil starter -- Stops running engine.
RECOIL STARTER-
Used for starting the engine
manually.
SPRAY GUN ASSEMBLY
(Contains Gun and Wand)-
Controls the application
of water onto cleaning surface
with trigger device.
OIL FILL- Port where engine oil is poured.
GAS TANKJCAP-
Cap is removed and unleaded
gasoline is poured.
CHEMICAL
INJECTION
TUBE AND FILTER- Mixes
water and detergent
in outlet water flow.
HIGH PRESSURE
OUTLET-
Connection
for high pres-
sure hose.
CHOKE-
Lever used for starting unit.
SPRAY
GUN
ASSEMBLY
HANDLE
HIGH PRESSURE
HOSE_
ENGINE
CHEMICAL
INJECTOR
TUBE & FILTER
HIGH
PRESSURE
OUTLET
WATER
INLET
CONNECTION
RECOIL
OIL FILL
PUMP
7
Advertisement
