Advertisement
3. Pull tdgger on gun handle to relieve any water
pressure.
4. Disconnect the wand from the gun.
5. Remove nozzle from the the end of the wand with
the 2ram allen wrench provided.
6. Clean the nozzle usingthe nozzle cleaner provided
or a straightened paper clip. Insert intothe nozzle
end and work back and forth untilobstructionsis
removed.
7. Direct water supply into nozzleend to backflush
loosened particles for 30 seconds.
8. Reassemble the nozzle to the wand. Tightan
securelyto prevent leaks.
9. Reconnect wand to gun and turn on water suppply.
10. Start pressure washer and place wand into high
pressure setting to test.
Preparing
Pressure
Washer
for Storage
NOTE: If you do not plan to use your unit for 30 days or
more, unit should be prepared for storage.
IMPORTANT: It is important to prevent gum deposits
from forming in essentialfuel system parts such as the
carburetor,fuel filter hose or tank during storage. Also,
experience indicates that alcohol-blended fuels (called
gasoholor using ethanol or methanol)can attract mois-
ture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system
of an engine while in storage. To avoid engine problems,
the fuel system should be emptied before storage of 30
days or longer.Never use engine or carburetor cleaner
products in the fuel tank or permanent damage may
occur.
Engine Preparation
• First add a fuel stabilizer to the fuel tank.
• Run pressurewasherforafull5minutestoailowfuel
stabilizer
to enter the fuel system.
• Next shut off engine and disconnect the water
supply.
• Disconnect the spark plug wire and remove the spark
plug.
• Add one teaspoon
of oil through the spark plug
hc4e.
• Place rag over spark plug hole and pull the recoil a
few times to iubricate the combustion chamber.
• Replace the spark plug, but do not connect the spark
plug wire.
l a, CAUTION: While while preparing the engine make
sure water supply is turned on and flowing to the
unit. NEVER rununit withoutwater supply running
through pump. Failureto do so willcause pump
damage.
Pump Preparation
This pressure washer should be stored in such a way
to protect it from freezing. Do not store this unit out-
doors or in an area where temperatures will fall below
32 ° E This can cause extensive damage to this unit.
If unit has to be stored under freezing conditions a non-
toxic R.V.anti-freeze should be put in the pump ac-
cording to steps below to protect from freezing.
• Be sure engine switch is in "OFF" position and spark
plug wire has been removed from spark plug.
• Pull the trigger on the spray gun to release the
pressurein
the high pressure hose. Detach high
pressure hose and garden hose from the unit.
• Pullthe recoil on the engine 4 to 6 times to discharge
remaining water in pump.
• Tip the unit on the end with the water inlet fitting
pointing upward.
• If unit will be stored where temperturee
fall below
32°F, pour approximately 1/4 cup of non-toxic R.V.
anti-freeze down the fitting where the water hose
attaches to the pump.
• Set unit upright and pull starter handle on engine 4 to
6 times to circulate anti-freeze
in pump until anti-
freeze is discharged
from the pump.
14
Advertisement
