Printing And Copying Problems - Epson 1000 ICS Basics Manual

You cancelled the software
installation before it was
complete, or you connected
the EPSON 1000 ICS
before starting the software
installation.
You're having problems
installing the software.

Printing and Copying Problems

Only the POperate light
is on, but nothing prints.
40
Problems and Solutions
Your EPSON software may be incorrectly installed. See
page 48 to uninstall your software. Make sure you follow
the steps on your Start Here poster carefully when you
reinstall your software. You need to connect the EPSON
1000 ICS at the correct time during installation so that it
is detected by the driver.
Make sure your system meets the requirements
beginning on page 51. Close your other applications,
including any screen savers and virus protection
software and install again.
Make sure that the Universal Serial Bus (USB)
Controller is working properly in Device Manager; see
your computer documentation. If it is not working,
contact your computer dealer.
If you see an error message or the software
doesn't install correctly on Windows XP or
Windows 2000, you may not have software
installation privileges.
If you're printing over a network, see your electronic
Reference Guide for instructions on configuring your
EPSON 1000 ICS for use on a network.
It takes several minutes to install the software. Don't
cancel the installation or open any other programs
during the installation process.
Make sure the USB cable is connected securely and
that the cable meets the system requirements on
page 51.
Run a nozzle check as described on page 39. If the
check page prints, make sure your EPSON 1000 ICS
software is installed correctly.
If you're printing on a network, you need to set up
your EPSON 1000 ICS for network printing, as
described in your electronic Reference Guide.