Cable Adjustment - Craftsman 536.887994 Operator's Manual

_'_l,]= WlI I .,y:l .,]qiU_,._l I ivi I QI i i
TRACTION DRIVE CABLE ADJUSTMENT
1, Run the engine until the fuel tank is 7, Push the bottom of the traction
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing.
3. Loosen the bolts on each side of
the bottom panel (see Figure 25).
Bolt Bottom Panel
Auger
Housing
drive cable through the cable ad-
justment bracket until the "Z"
hook can be removed.
8. Remove the "Z" hook from the
cable adjustment bracket. Move
the "Z" hook down to the next ad-
justment hole.
9. Pull the traction drive cable up
through the cable adjustment
bracket.
10. Put the cable boot over the cable
adjustment bracket.
11. Install the "Z" hook to the traction
drive lever (see Figure 23).
12. To check the adjustment, depress
the drive lever and check the length
of one of the drive springs. In cor-
rect adjustment, the length of the
drive spring is:
minimum 3" (76 mm.)
maximum 3-3/8" (85 mm.)
(see Figure 27).
Figure 25
4. Remove the bottom panel.
5. Disconnect the "Z" fitting from the
drive lever (see Figure 23).
6. Slide the cable boot off the cable
adjustment bracket (see
Figure 26).
3" min.,
3-3/8" max.
/ /
TractiooS
, )_able riveB°ot_-_ j Cable/,}
,#:-Y 4_¢ _-
Cable_Adjustment /_ "Z" Hook
Bracket Figure 26
Drive Spring Figure 27
F-0310107L 24