Gas Requirements - Fisher & Paykel Dryer Installation Instructions Manual

The installation must co ]form with Local Codes, or i t] t he a bsence of L ocal Codes, to the N atio ]al iiiiiiiii!!!
Fuel Gas Code ANSi Z22S._/NFPA S4 orthe Canadian Natural C_as and Propane InstaUat_on Code,
CSA B149.1.
£×D[osion Hazard
installations must be performed by a qua[i_ed or licensed
contractor, plumber, or gas_tter qualified or licensed by the stat÷_
province, or region where this appliance is being installed°
Usea new AGA or CSAapproved gas supply [ineo
Insta[[ a shuboff vaJve in an accessibJep[aceo
OnJy use a gas shut-off vaJveapproved for use within the stat÷_
province, or region where this appJiance is being instaJJedo
Securely tighten a[[ gas connections°
Failure to follow these instructions can result in death, e×pJosion_
or _reo
GasType
Your dryer must have the correct burner for the type of gas in your home. Burner information is
located or] the rating plate located or] the front of the dryer behind the door. If this information
does not agree with the type of gas available in your home, contact your local Fisher& Payke[
supplier or service center.
Natural Gas
This dryer is supplied ready for use with Natural Gas.
It is design certified by CSA International for LP(Propane or Butane) Gaseswith the appropriate
conversion.
LP Gas Conversion
If the dryer is to be operated or] LP (Liquid Propane or Butane) Gas,the dryer must be converted.
To do so, use only the approved Fisher& Payke[conversion kit listed in Accessories or] page 9. Do
not use with a different gas without consulting the serving gas supplier.
The dryer must be converted for safe and proper performance by qualified service or installation
personne[.
Conversion kits for Natural and LPGas are available from your local Fisher& Paykel Dealer (see
Accessories page 9). If other conversions are required, check with your local gas utility for specific
information concerning conversion requirements.
25