Lp Gas Conversion - Fisher & Paykel AeroSmart Series Installation Instructions And User Manual

,L stalllatio ilnst 'uctior s
Gas requiremertts (gas models ordy}
The installation must conform with Local Codes, or in the absence of Local Codes, to the
National Fuel Gas Code ANSI Z223,1/NFPA 54 or the Canadian Natural Gas and Propane
Installation Code, CSA B14g.l.
Explosion Ha_rd
_nstaHations must be performed by a qualified or _icensed contractor,
p_umber, or gasfitter qualified or _icensed by the state, province, or region
where this appliance is being instaHedo
Use a new AGA or CSA approved gas supply _ineo
Install a shut-offva[ve in an a<cessib[e p[aceo
Only use a gas shut-off valve approved for u_ within the state, province, or
region where this appliance is being instaHedo
Securely tighten aH gas connections.
_f connecting to LP Gas, have a qualified person make sure gas pressure
does not exceed 13"(330 ram} water co_umno
Failure to follow these instructions can result in death, explosion, or fire.
Gas type
'four dryer must have the correct burner for the type of gas in your home. Burner information
is ocated on the rating plate located on the rear of the console. [f this information does not
agree with the type of gas available in your home, contact your local Fisher & Paykel supplier or
service center.
This dryer is supplied ready for use with Natural Gas.
It is design certified by UL International for LP (Propane or Butane) Gases with the appropriate
conversion,
LP gas conversion
If the dryer is to be operated on LP (Liquid Propane or Butane) Gas, the dryer must be
converted. To do so, use only the approved Fisher & Payke[ conversion kit listed in Accessories
on page 7. Do not use with a different gas without consulting the serving gas supplier.
The dryer must be converted for safe and proper performance by qualified service or installation
personek
Conversion kits for Natural and LP Gas are available from your local Fisher & Payke[ Dealer
(see Accessories page 7) If other conversions are required, check with your local gas utility for
specific information concerning conversion requirements.