Lighting Instructions - Napoleon PRESTIGE V 450 Manual

6

Lighting Instructions

Pilot
Burner
Lighting Hole
WARNING!
WARNING!
Main Tube Burner Lighting
1. Open grill lid
2. Turn left or right tube
burner control to high.
3. Press and hold left igniter
switch until burner lights,or
light by match.
4. If ignition is not
immediate, turn burner
control off. Wait 5 minutes.
5. With one tube burner
operating in the high
position, turn the other tube
burner control to high.
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Main Left
Infrared Igniter
Burners
Open lid
Ensure all burner controls are in the off position. Slowly turn on the gas
supply valve.
Rear Infrared Burner Lighting
1. Open grill lid
2. Remove warming rack.
3. Turn rear burner valve on,
push in, and hold.
4. With valve held in, push
and hold left igniter switch
until rear burner lights.
Repeat.
5. Keep valve depressed for
10-15 seconds and release.
6. If ignition is not immediate,
turn the burner control off.
Wait 5 minutes.
Repeat
7. Once burner is lit, allow a 5
minute pre-heat period before
adjusting to med or low.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use rear burner while operating main burner.
Lights
Main Front Right
Tube Side Igniter
Burners Burner
Main Infrared Burner Lighting
1. Open grill lid
2. Turn pilot burner control
to high.
3. Press and hold left igniter
switch until pilot lights,or
light by match.
4. Once pilot is lit, turn left
and/or right infrared burners
to high.
5. If ignition is not immediate,
turn burner control off. Wait
5 minutes.
6. Once infrared burner is lit,
leave on high for 5 minute
pre-heat period before
adjusting to medium or low.
7. Keep pilot on while
operating infrared burners.
Turn off after use.
Rear
Infrared
Burner
Rear
Side
Burner
Off Position
Side Burner Lighting
1. Open burner cover.
2. Turn front or rear side burner
control to high.
3. Press and hold right igniter
switch until burner lights, or
light by match.
4. If ignition is not
immediate, turn burner control
off. Wait 5 minutes. Repeat.