NETGEAR WGT624 Reference Manual page 23

2. Start your network in the correct sequence.
Warning: Failure to start or restart your network in the correct sequence could
a. First, plug in and turn on the cable or DSL modem. Wait 2 minutes.
b. Now, plug the power cord into your wireless router and into a power outlet. Wait 1 minute.
c. Last, turn on your computer.
Note: For DSL customers, if software logs you in to the Internet, do not run that
Figure 1-8
d. Check the wireless router status lights to verify the following:
• Power: The power light should turn solid blue. If it does not, see
Not On" in Chapter
• Test: The test light should turn solid green when the router is first turned on, then
go off. If after 2 minutes it is still on, see
• Wireless: The wireless light should be on. The Smart Wizard sets up the wireless
feature of your router.
• Internet: The Internet port light should be lit. If it is not, make sure that the
Ethernet cable is securely attached to the wireless router Internet port and that the
modem, and the modem is powered on.
• LAN: A LAN light should be lit. Green indicates that your computer is
communicating at 100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check
that the Ethernet cable from the computer to the router is securely attached at both
ends, and that the computer is turned on.
Connecting the Router to the Internet
108 Mbps Wireless Router WGT624 v4 Reference Manual
prevent you from accessing the Internet.
software. You may need to go to the Internet Explorer Tools menu > Internet
Options > Connections tab page and select "Never dial a connection."
6.
v1.2, July 2007
"Basic Functioning" in Chapter
"Power LED
6.
1-9