Control Panel - Napa 85-300A Owner's Manual

11. CONTROL PANEL

LED Indicators
(POWER ON) green LED: The charger is connected to an AC
power source and is receiving power.
(CHARGED) red LED: The battery is fully charged and the
charger is in maintain mode.
12. OPERATING INSTRUCTIONS
accordance with the assembly instructions before it is used.
the 120V AC outlet, or it could result in damage to the charger.
The charger does not have an ON/OFF switch. The On and Off
commands are controlled by plugging the charger into a 120V AC
electrical wall outlet only after the battery connections have
been made.
Charging
1. Ensure that all of the charger components are in place and in
good working condition.
2. Connect the battery following the precautions listed in
sections 6 and 7.
3. Connect the AC power, following the precautions listed in
section 8.
4. The
connected. When the battery is charged, the
will light.
5. To disconnect, reverse the procedure.
NOTE: This charger is equipped with an auto-start feature.
Current will not be supplied to the ring terminals until a battery is
properly connected. The clips will not spark if touched together.
Automatic Charging Mode
When an Automatic Charge is performed, the charger switches to
the Maintain Mode (see below) automatically after the battery is
charged. For a battery with a starting voltage under 1 volt, use a
manual charger to pre-charge the battery for five minutes to get
additional voltage into the battery.
This battery charger must be properly assembled in
Do not start the vehicle with the charger connected to
(green) LED will light when the AC cord is properly
• 10 •
(red) LED