Chapter 5 Setting
Details of mending can be set in case of a thread breakage.
1.
2.
3.
100
Setting of Mending
Contents of each setting item are as described below.
Item
Contents
For setting a mending end point (number of stitches before a thread
breakage) within the range of 1 ~ 10.
This function is previously set to 1 stitches upon shipments.
For setting whether to reset a thread breakage error automatically
This function is previously set to
For setting whether to stop embroidering temporarily at the mending end point
For setting a thread trimming method using the
resetting a thread breakage error. (This setting is effective only once
after resetting the error.)
Refer to "Mending" (
Press
.
Select
by pressing
Press
.
BES-941BC • BES-1241BC
For resetting an error automatically
For resetting an error manually
For stopping embroidering at the mending end point
For stopping embroidering temporarily at the mending end point
and then starting all heads automatically
For not stopping embroidering at the mending end point and
continuing embroidering
Manually trim the lower thread immediately after resetting a
thread breakage error if feeding by stitch back is long (i.e., 40 to
50 mm or more) in this mode.
Set the thread trimming method to
For trimming both upper and lower threads
For trimming the lower thread only
For not trimming any thread
Page 127).
.
(Manual) upon shipments.
.
immediately after