Hotpoint RGB790WEKWW - Gas Range Owner's Manual page 46

Before you call for service...
Troubleshooting -tips
i Possible Causes What To Do
Excessive smoking Excessive soil. * Touch tile CLEAR/OFF pad. Open tile windows to rid
tile room of smoke. \_'ait until tile li_d_t (m tile
SELF
CLEANpad
goes oil _Vipe up tile excess" soil and reset
the cle:m cycle.
Oven door willnotopen
Oven too hot. * _Mh)w the oven to cool below locking temperature.
after a clean cycle
Oven not clean after Oven controls not properly set. * See the Using the self-cleaning oven section.
a
clean cycle
Oven was heavily soiled. * Cle;m u}_ heavv, s}_illove_ before starting, the clean cycle.
Heavily soiled ovens may need to sell:clean again or fin.
a hmger period of time.
Oven door will not
Oven is too hot.
* _Mlow the
oven to cool below locking temperature.
unlock (on models Do not lock
the door
with the
door
latch except when
with a doorlatch)
usin,, the self=clean feature.
"Door"appears in the
Self-clem_h_g cycle has been
* Move
the latch handle all the way to the fight.
display (on models selected but the latch handle
with a doorlatch)
was not
moved all the way
to the fight.
Latch handle was moved to the * Move the latch handle to the right only when ,setfiw,
fight but a progrmn other than the sell=cleaning cycle.
self-clemahag was selected.
"T--and a number or On models with a door latch, * The latch may have been moved, even if only slightly,
letter" flash in the
display
if a function error code appears fl'om the locked position. Make sure the latch is moved
during the self-clemahlg cycle, to the right as far as it will _o
check the oven door latch.
You have a fm_ction error code. * Touch the
CLEAR/OFF
pad. _Mlow the oven to cool fin"
()lie hot/I: Pt/t the oven back into operation.
If the function code repeats. * Disc(rancor all power to the range for 5 minutes
nnd then
l'econnect
powel: If the
filllcti()ll elTOl"
code repeats, call for service.
Display goes blank A fuse in your home may he * Replace the fllse or reset the circuit breaker:
blown or the circuit
breaker tripped.
The clock is turned off so that it * See the Using the clock and timer secti()n.
does not show in the display.
Display flashes Power failure.
Unable to get the Oven conlrol pads were
display to show "SF" not touched properly.
• Reset the clock.
• The BAKE and
BROILHI/LO
pads must be touched at
the same time and held fo_ 3 seconds.
46