Clock And Timer - Hotpoint RGB540SEP - 30 in. Gas Range Owner's Manual

Usingthe clock and timer.
Throughout this manual, features and appearance may vary from your model.
f
@ db
You have the choice of having the timer show the time counting
down or the time of day. In either case, the timer will signal at the
end of the timer period to alert you that the time is up.
@
db
To Set the Clock
NOTE:Whenyou first plug in the range or after
a power failure, the entire Clock/Timerdisplay will
light up.
[] Pressthe CLOCKpad.
[] Pressand hold the + or - pad and the time
of day will change 10 minutes at a time. To
change the time by single minutes, give the
pads short taps.
r-_ Pressthe CLOCKpad to start the clock.
To Set the Kitchen Timer
[-il Pressthe KITCHENTIMERON/OFF pad.
Use the + and - pads to set the timer. Short
taps on the + or - pad change the timer's
setting one minute at a time. Pressing and
continuing to hold the + pad increases the
setting 10 minutes at a time.
r-_ once you have set your timer, press the
KITCHEN TIMER ON/OFF pad to start
timing.
As the timer counts down, a signal will indicate
when one minute is left. After this signal, the
display will count down in seconds. When time
runs out, a final signal will sound. Pressthe
KITCHENTIMERON/OFF pad to stop the signal.
To Change or Cancel the Kitchen Timer Setting
When the timer is counting down, use the + and
- pad to change the remaining time, or press
the KITCHENTIMERON/OFF pad to stop the
timer. The timer cannot be cancelled unless you
have fully completed "set timer" instructions
above.
Display Clock While Kitchen Timer Is Operating
Pressing the CLOCKpad while the timer is
operating will not interfere with the timer's
operation; the display will change to show the
clock, but the timer will continue to count down
and will still signal when time is up. Pressthe
KITCHENTIMERON/OFF pad again to change
the display back to show the timer.