Display Assembly; Removing The Display Assembly - Dell Precision M90 Service Manual

Back to Contents Page
Display
Dell Precision™ M90 Mobile Workstation Service Manual
Display Assembly
Display Bezel
Display Panel
Display Latch
Display Assembly

Removing the Display Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1. Follow the instructions in Before Working Inside Your
2. Turn the computer upside-down and loosen the two captive screws on the Mini-Card cover.
NOTE: You must detach the Mini-Card antennas (see
antenna cables from the card. If one is not installed, detach the antenna cables from their secured location.
3. Disconnect the antenna cables from the Mini-Card, if applicable.
4. Turn the computer top-side up.
5. Remove the hinge cover (see
6. Use the pull-tab to disconnect the display cable from the system board, and then disengage the display cable from the cable channel.
Computer.
step 3) before you can remove the display assembly. If a Mini-Card is installed, disconnect the
Removing the Hinge Cover).