Craftsman 917.272245 Owner's Manual page 23

TO REPLACE MOWER BLADE (SEC-
ONDARY) DRIVE BELT
Park the tractor on level surface. Engage
parking brake.
1, Remove mower (See "TO REMOVE
MOWER" in this section of manual).
2. Remove screws from R,H. and L.H.
mandrel covers and remove covers.
REMOVE MOWER DRIVE BELT
(Refer to 'frO REMOVE MOWER DRIVE
BELT" illustration in this section of
manual).
3. Carefully roll belt over the top of R.H.
mandrel pulley.
4. Remove belt from idler pulleys.
5. Check primary idler arm and two
idlers to see that they rotate freely.
6. Be sure spring is securely hooked to
primary idler arm and spring arm.
REMOVE MOWER BLADE
(SECONDARY) DRIVE BELT
7. Carefully roll belt off L.H. mandrel
pulley.
8. Remove belt from center mandrel
pulley, idler pulley, and R.H. mandrel
pulley.
9. Remove any dirt or grass which may
have accumulated around mandrels
and entire upper deck surface.
Secondary
Idler Arm Idler
LH. Pulley
Mandrel
10.Check secondary idler arm and idler
pulley to see that they rotate freely.
11. Be sure spring is hooked in secondary
idler arm and secondary spring arm.
INSTALL NEW MOWER BLADE
(SECONDARY) DRIVE BELT
12.Install new belt in lower groove of R.H.
mandrel pulley, idler pulley, and
center mandrel pulley as shown.
13.Carefully roll belt over L.H. mandrel
pulley. Make sure belt is in all
grooves properly.
REINSTALL MOWER DRIVE BELT
(Refer to "TO REMOVE MOWER DRIVE
BELT" illustration in this section of
manual).
14. Install belt into upper groove of R.H.
mandrel pulley and around both
idlers. Pull belt to front of mower to
remove slack.
15. Reinstall mandrel covers and securely
tighten all screws.
16.Carefully check belt routing making
sure belt is in all grooves correctly.
17. Reinstall mower to tractor (See "TO
INSTALL MOWER" in this section of
manual).
SI_"
Secondary
Spring Arm
Center
Mandrel
Mower Blade
(Secondary)
Drive Belt
R.H.
Mandrel
23