Advertisement
Chute
..Assembly
(K)
Hex Lock Nut
(M)
Chute Flange
Keeper
Figure 11
Hex Bolts (K)
Hex Lock Nuts (M)
Flat
Chute
Directional
Control
ATTACHING THE CHUTE ASSEMBLY
(Hardware F)
1.
Place chute assembly over chute opening, with
the opening in the chute assembly facing the
front of the unit. Place chute flange keepers
beneath lip of chute assembly, with the flat side
of chute flange keeper facing downward.
2,
Insert
hex
bolt (K) up through chute flange
keeper and chute assembly as shown in Figure
11.
Secure
with
hex
lock nut (M).
After
assembling
all three
chute flange
keepers,
tighten all nuts and bolts securely. Do not
overtighten.
Note: Locknuts cannot be threaded onto a bolt by
hand. Tighten with 2 7/16" wrenches. This type of
nut is used where vibration occurs.
ATTACHING THE CHUTE DIRECTIONAL
CONTROL (Hardware G)
1.
Loosen the two hex nuts which secure the lower
chute directional
control support
bracket
(see
Figure 12) to the snow thrower housing.
2,
Place one flat washer (T) over the end of the
chute directional control, then insert the end of
the chute directional control into the hole in the
plastic bushing in the chute bracket. See Figure
13. Place second flat washer (T) on chute
directional control, and secure with hairpin clip
(s).
.
Thread one hex nut (D) onto the eyebolt on the
chute directional control assembly until there is
at least two inches of threads showing between
the nut and the head of the eyebolt. See Figure
14.
.
Place the eyebolt into the hole located half way
up the left handle. Secure with cupped washer
(N) (cupped side against the handle, see inset,
Figure 14) and hex nut (D).
5,
Adjust
the chute directional
control support
bracket (see Figure 13) so that the spiral on the
chute directional control fully engages the teeth
on the chute assembly. Tighten the hex nuts on
the
lower
chute
directional
control
bracket
securely. Tighten the hex nuts on the eyebolt.
6.
Check to make sure all nuts and bolts on the
control panel and all four bolts which secure the
handles to the frame are tight.
Figure 13
Advertisement
