Advertisement
HexBolt
(8)
Saddle
Lock Washer
(c)
(A)
Lock Washer(C)
Figure 4
Pivot Rod
ATTACHING THE HANDLES
(Hardware A)
1.
Place right handle in position against the snow
thrower so the flat side of the handle is against
the frame. Secure bottom hole in handle to snow
thrower using hex bolt (B) and lock washer (C).
There are weld nuts welded to the inside of the
frame for these bolts, See Figure 4. Do not
tighten at this time.
2.
Attach the left handle in the same manner. Do
not tighten at this time.
3,
Place saddle (I) over upper holes on handles
(curve matching curve on handle). Secure to the
frame with lock washers (C) and hex bolts (A).
See Figure 4. Do not tighten at this time.
ATTACHING THE CLUTCH GRIPS
(Hardware B)
1.
Slide the pivot rod into the cover tube as shown
in Figure 5. The pivot rod and cover tube may
already be assembled.
Figure 5
Hex Nuts (D)_
,
Place the clutch grips in position on the rod so
the flat side of the clutch grips are against the
pivot rod cover, Thread hex nuts (D) onto each
end of the rod. Tighten nuts allowing the clutch
grips to move freely on pivot rod. See Figure 6,
Figure 6
Clutch Grip and
Rod Assembly_
S_'_"
Handle
Tab
\
Hex Nut (D)
,
Insert clutch grip and rod assembly into handle
tabs. Clutch grips must sit on top of the handles.
Thread hex nuts (D) on each end to hold into
position. Do not tighten, See Figure 7.
Figure 7
7
Advertisement
