Craftsman 358.350200 Instruction Manual page 20

TROUBLESHOOTING TABLE - Continued
TROUBLE CAUSE REMEDY
Oil inadequate t. Oil tank empty, t. FiII oil tank.
for bar and 2. Oil pump or oil filter 2 Contact Sears Service.
chain clogged.
lubrication. 3. Guide bar oil ho_e 3 Remove bar and cIean.
blocked.
Chain moves at t. idle speed requires 1. See "Carburetor Adjustment" in
idle speed, adjustment Service and Adjustments Section
2. C_utch requires repair 2. Contact Sears Service
Chain does not t. Chain tension too 1. See "Check Chain Tension" in the
move when an- tight. Maintenance Section
gtne is acceier- 2. Carburetor requires 2. See "Carburetor Adjustment" in the
ated. adjustment. Service and Adjustments Section.
3. Guide bar rails 3. Repair or replace.
pinched.
4. CIutch s}ipping.
5. Chain brake engaged.
Chain clatters 1. Chain tension incorrect.
or cuts rougMy.
2 Cutters damaged
3 Chain worn.
g Cutters dull, improperly
sharpened, or depth
gauges too high.
5. Sprocket worn.
8 Chain installed
backwards.
4. Contact Sears Service.
5. Disengage chain brake
t See "Check Chain Tension" in the
Maintenance Section.
2. Contact Sears Service.
3 Resharpen or replace chain.
4 See "Chain Sharpening" in the
Service and Adjustments Section.
5 Contact Sears Service.
6 install chain in right direction.
Chain stops 1. Chain cutter tops not t See "Chain Sharpening" in the
within the cut. filed flat. Service and Adjustments Section.
2. Guide bar burred or 2 Repair or replace guide bar
bent; rails uneven.
3 Clutch slipping. 3 Contact Sears Service.
Chain cuts at t. Cutters damaged on t See "Chain Sharpening" in the
an angle, one side Service and Adjustments Section.
2. Chain dull on one side. 2 See "Chain Sharpening" in the
Service and Adjustments Section.
3. Guide bar bent or worn 3 Replace guide bar.
tf situations occur which are not covered in this manual, use care and good
judgement, if you need assistance, contact Sears Service or the CUSTOMER
ASSISTANCE HELPUNE at t-800-235-5878,
YOUR WARRANTY RIGHTS AND
OBLIGATIONS: The U. S. Environ-
mental Protection Agency and Sears,
Roebuck and Co., U.S.A., are pleased
to explain the emissions control sys-
tem warranty on your lawn and garden
equipment engine. Att new utility and
lawn and garden equipment engines
must be designed, built, and equipped
to meet the stringent anti-smog stan-
dards, Sears must warrant the emis-
sion control system on your lawn and
garden equipment engine for the peri-
ods of time listed below provided there
has been no abuse, neglect, or im-
proper maintenance of your tawn and
garden equipment engine. Your emis-
sion control system includes parts
such as the carburetor and the ignition
system. Where a warrantable condition
exits, Sears witi repair your lawn and
garden equipment engine at no cost to
you. Expenses covered under warran-
ty include diagnosis, parts and labor,
2O