4.
Turn on the terminal and access the Setup Directory. Set the following parameters:
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix N Standalone Series Configuration Guide for further
information.
Figure 3-13
1 UTP cable with RJ45 connectors
2 RJ45 COM port
Connecting to a Modem
To connect a modem to the device COM port (Figure
connectors and an optional RJ45‐to‐DB25 male adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the cable to the COM port of the module.
2.
Plug the RJ45 connector at the other cable end into the RJ45‐to‐DB25 modem adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Connecting a VT Series Terminal
Ã
Â
Connecting to the COM Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
À
3 RJ45-to-DB25 VT adapter
4 VT series terminal
3‐14), use a UTP cable with RJ45
N Standalone Series Installation Guide 3-15
Á