Table of Contents
Advertisement
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
ROUTER: The commands covered in this chapter can be executed when the device is
in router mode only. For details on how to enable router configuration modes, refer to
Section
3.3.3.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1. Configuring RIP
2. Configuring OSPF
3. Configuring DVMRP
4. Configuring IRDP
5. Configuring VRRP
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
Routing Protocol Configuration
(Section
13.1.1)
(Section
13.1.2)
(Section
13.1.3)
(Section
13.1.4)
(Section
13.1.5)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13
13-1
Advertisement
Table of Contents
