Table of Contents
Advertisement
1.5 REAR PANEL
During initial setup you will be connecting your DVR to multiple input and output devices. This is done
through the rear panel.
POWER:
Power input 100~240 VAC.
○
1
eSATA port: Used for external SATA HDD bay
○
2
Audio In:
Connect line level output of an audio preamplifier to the audio input connection
○
3
corresponding to the appropriate camera.
LAN:
RJ-45 socket for 1 GB network interface, connectabe also to 10/100 Mbps network
○
4
structures. There are two LEDs on the LAN jack; Green LED means network is
connected, amber LED flickers when data is being exchanged.
USB 2.0:
USB port recommended for connecting the USB mouse.
○
5
RS232 socket: 9-pin D-Sub RS-232 interface (for service and support purpose)
○
6
Figure 1-2 Rear Panel
6
Advertisement
Table of Contents
