Enterasys ANG-1000 User Manual page 34

After a few moments when an IP address has been received for the external
port, the Internet LED will turn on. If a static IP address was configured, the
Internet LED will shine immediately.
22
– Enter the Gateway IP address.
– Specify the Primary DNS IP address.
– Set the Secondary DNS IP address.
– Click Apply.
H Click the PPPoE assigned IP address radio button and perform
the following steps:
– Specify a Username supplied by your cable/DSL provider.
– Enter a Password.
– Type the password again in the Confirm field.
Click Apply.
–
3 If you chose the Manual or PPPoE options, a window appears
detailing the reconfiguration changes and prompting you to reboot the
ANG-1000. Click Reboot Now.
NOTE
If you press the reset button after you have configured your ANG-1000,
you will lose your entire configuration. Any settings you supplied must
then be re-entered. We strongly recommend that you do not use the reset
button unless you want the configuration to return to factory defaults.
Configuring the ANG-1000 with Aurorean Web Config
Aurorean Network Gateway-1000 User's Guide
Chapter 3