Enterasys ANG-1000 User Manual page 22

Checking ANG-1000 Connections
After the ANG-1000 is configured and in use, the Internet, VPN, RX and TX
LEDs will light and/or blink. Refer to Figure 12 for behavior of the LEDs.
The ANG-1000 is now ready for configuration. Refer to Chapter 3 for detailed
instructions.
10
Figure 11 ANG-1000 Front Panel
Power On when ANG is powered up
Blinks when CPU is active
Active
On when External network is assigned an IP address
Internet
On when a tunnel is connected
VPN
Blinks when data is transmitted
TX
Blinks when data is received
RX
Figure 12 ANG-1000 Front Panel LEDs
NOTE
COM1 and COM2 LEDS are not operational at this time.
Aurorean Network Gateway-1000 User's Guide
Chapter 2
Installation