Table of Contents
Advertisement
Using the Timers
The ABX-100 has three timers: two programmable
timers for automated playback, and a sleep timer for
turning the ABX-100 off after a specified period.
About the Timers
The various settings for the two programmable timers
are explained here. For details on the sleep timer, see
page 13.
Repeat Timers
Each timer can be programmed to operate every week or
every day.
• Every
The timer will operate every week on the specified
day and time.
• Everyday
The timer will operate every day at the specified
time.
Programming the Timers
Notes:
• You must set the clock before you can program the
timers.
• If you don't operate any buttons for one minute while
programming a timer, the procedure will be cancelled.
• Timer settings can be made only while the ABX-100
is in standby mode. If the ABX-100 is powered-on,
press the [] button to put the unit in standby mode.
• Connect your iPod/iPhone to the iPod Dock, and make
it ready for playback.
M
TIMER
F, H
12
En-
(by remote controller only)
1
2
3
4
5
6
7
SNOOZE
DISPLAY
8
Q, R
ENTER
Press the [TIMER] button.
Use the []/[] buttons to select "Timer1
Setup" or "Timer2 Setup".
Timer1 Setup
Timer2 Setup
Clock
Setup
Press the [ENTER] button.
Use the []/[] buttons to select "Timer1
On" or "Timer2 On", and then press the
[ENTER] button.
Use the []/[] buttons to specify the On
time, and then press the [ENTER] button.
Use the []/[] buttons to specify the Off
time, and then press the [ENTER] button.
Timer1 Setup
Timer1
On
Off
Use the []/[] buttons to select "Everyday"
or "Every", and then press the [ENTER]
button.
If you selected "Everyday", proceed to step 9.
If you selected "Every", use the []/[]
buttons to select the day of the week on
which you don't want timer playback to
occur; then use the []/[] buttons to make
the underline character appear in place of
that day of the week, and then press the
[ENTER] button.
Timer1 Setup
Every
MoTuWeThFr
On
6:30
7:00
Advertisement
Table of Contents
