Table of Contents
Advertisement
_
WARNING:Whenservicing, useonlyidentical
Craftsman r eplacement parts.Useof anyother
partmaycreatea hazard or causeproduct
damage.
GENERAL
Onlythepartsshown onthepartslist,areintended to
be repaired or replaced bythecustomer. Allother
partsrepresent animportant partof thedouble
insulation s ystem andshouldbeserviced onlybya
qualified Searsservice technician.
Avoidusingsolvents whencleaning plastic parts.
Mostplastics aresusceptible t o damage fromvarious
typesof commercial solvents andmaybedamaged
by theiruse.Usecleanclothsto remove dirt,carbon
dust,etc.
_k WARNING:Donotatanytimeletbrakefluids,
gasoline, petroleum-based products, penetrating
oils,etc.comeincontact w ithplasticparts. T hey
contain chemicals t hatcandamage, weaken or
destroy plastic.
It hasbeenfoundthatelectric toolsaresubject t o
accelerated w earandpossible premature f ailure when
theyareusedonfiberglass boats, s ports cars,
wallboard, spackling compounds, or plaster. T he
chipsandgrindings fromthesematerials arehighly
abrasive to electric toolpartssuchas bearings,
brushes, c ommutators, etc.Consequently, it is not
recommended thatthistoolbeusedfor extended
workon anyfiberglass m aterial, wallboard, spackling
compounds, or plaster. D uring anyuseonthese
materials i t is extremely i mportant thatthetoolis
cleaned frequently byblowing withanairjet.
CUTTERS
Getfastermoreaccurate cuttingresults by keeping
cutters cleanandsharp.Remove a ll accumulated
pitchandgumfromcutters aftereachuse.
Whensharpening c utters, s harpen onlytheinsideof
thecuttingedge.Nevergrindtheoutside diameter. Be
surewhensharpening t heendofa cuttertogrindthe
clearance anglethesameasoriginally ground.
COLLET
From timeto time,it alsobecomes necessary t oclean
yourcolletandcolletnut.Todoso,simplyremove
colletnutfromcolletandcleanthedustandchipsthat
havecollected. Thenreturncolletnutto itsoriginal
position.
LUBRICATION
Allof thebearings inthistoolarelubricated witha
sufficient a mount o fhighgradelubricant forthelifeof
the unitundernormal o perating conditions. Therefore,
nofurtherlubrication i s required.
EXTENSION
CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent
tool overheating,
use an extension cord that is heavy
enough to carry the current the tool will draw.
A wire gage size (A.W.G.) of at least 14 is
recommended for an extension cord 100 feet or less
in length. When working outdoors, use an extension
cord that is suitable for outdoor use. The cord's jacket
will be marked WA.
a,
CAUTION:
Keep extension cords away from the
cutting area and position the cord so that it will
not get caught on lumber, tools, etc., during
cutting operation.
a,
WARNING:
Check extension cords before each
use. If damaged replace immediately. Never use
tool with a damaged cord since touching the
damaged area could cause electrical shock
resulting in serious injury.
Extension cords suitable for use with your router are
available at your nearest Sears Retail Store.
,_
WARNING:
Always wear safety goggles or
safety glasses with side shields during power
tool operation or when blowing dust. If operation
is dusty, also wear a dust mask.
18
Hide quick links:
Advertisement
Table of Contents
