WARNING:Before performing a nyadjustment,
makesurethetool isunplugged f romthe power
supply andthe switchis inthe
OFF ( O ) position.
Failure to heed this warning could result in serious
personal injury.
Your compound miter saw has been adjusted at the
factory for making very accurate cuts. However, some of
the components
might have moved out of alignment
during shipping. Also, over a period of time, readjustment
will probably become necessary due to wear. After
unpacking your saw, check the following adjustments
before you begin using saw. Make any readjustments
that
are necessary and periodically check the parts alignment
to make sure that your saw is cutting accurately.
POSITIVESTOP
ADJUSTMENT
SCREWFOR
45°ANGLES
PIVOT ADJUSTMENTS
NOTE: These adjustments
were made at the factory and
normally do not require readjustment.
TRAVEL
PIVOT ADJUSTMENT
•
The saw arm should rise completely to the up position
by itself.
•
If the saw arm does not raise by itself or if there is play
in the pivot joints, have saw repaired by a qualified
service technician at your nearest Sears Service Center
to avoid risk of personal injury.
BEVEL PIVOT ADJUSTMENT
•
Your compound miter saw should bevel easily by
loosening the bevel lock knob and tilting the saw
arm to the left.
•
If movement is tight or if there is play in the pivot, have
saw repaired by a qualified service technician at your
nearest Sears Service Center to avoid risk of personal
injury.
LOCK
Fig. 45
32