Table of Contents
Advertisement
• Before turningonthe saw,perform a dryrunofthecut-
tingoperation justto makesurethatnoproblems w ill
occurwhen thecutis made.
• Grasp thesawhandle firmly thensqueeze theswitch
trigger. A llowseveral seconds forthebladeto reach
maximum speed.
• Slowlylower the bladeintoandthrough theworkpiece.
• Release t he switchtriggerandallowthesawbladeto
stoprotating before raising the bladeoutofworkpiece.
Waituntiltheelectricbrake stopsbladefromturning
before removing t heworkpiece frommitertable.
BEVELCUT
Fig. 37
TO COMPOUND
MITER CUT
A compound
miter cut is a cut made using a miter angle
and a bevel angle at the same time. This type of cut is
used to make picture frames, cut molding, make boxes
with sloping sides, and for certain roof framing cuts.
To make this type of cut the control arm on the miter table
must be rotated to the correct angle and the saw arm
must be tilted to the correct bevel angle. Care should
always be taken when making compound miter setups
due to the interaction of the two angle settings.
Adjustments
of miter and bevel settings are interde-
pendent with one another. Each time you adjust the miter
setting you change the effect of the bevel setting. Also,
each time you adjust the bevel setting you change the
effect of the miter setting.
It may take several settings to obtain the desired cut. The
first angle setting should be checked after setting the
second angle, since adjusting the second angle affects
the first.
Once the two correct settings for a particular cut have
been obtained, always make a test cut in scrap material
before making a finish cut in good material.
TO MAKE A COMPOUND
CUT
•
Pull out the lock pin and lift saw arm to its full height.
•
Loosen the miter lock handle.
•
Rotate the saw table until the pointer aligns with the
desired angle on the miter scale.
•
Tighten the miter lock handle securely.
_k
WARNING:
To avoid serious personal injury, always
tighten the miter lock levers securely before making
a cut. Failure to do so could result in movement of
the control arm or miter table while making a cut.
•
Loosen the bevel lock knob and move the saw arm to
the left to the desired bevel angle.
•
Bevel angles can be set from 0° to 45 °.
•
Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
•
Recheck miter angle setting. Make a test cut in scrap
material.
•
Place the workpiece flat on the miter table with one
edge securely against the fence. If the board is warped,
place the convex side against the fence. If the concave
edge of a board could collapse on the blade at the end
of the cut, jamming the blade.
•
When cutting long pieces of lumber or molding, sup-
port the opposite end of the stock with a roller stand or
with a work surface level with the saw table.
•
Align the cutting line on the workpiece with the edge of
saw blade.
•
Grasp the stock firmly with one hand and secure it
against the fence or use the optional work clamp or a
C-clamp to secure the workpiece when possible.
NOTE: When making a 45° left miter and a bevel angle
greater than 30 °, you must use a C-clamp to secure the
workpiece or move clamp to the right side of the base.
_
WARNING:
To avoid serious personal injury, always
keep your hands away from cutting area. Never per-
form any cutting operation freehand (without holding
workpiece against the fence). The blade could grab
the workpiece if it slips or twists.
COMPOUND
MITER CUT
27
Fig. 38
Hide quick links:
Advertisement
Table of Contents
